14 Pieces Lathe Boring Bar Set 4 Pcs 95 Degree S07K/ S08K/ S10K/ S12M-SCLCR06 Lathe Boring Internal Turning Bar Holder with 10 CCMT0602 Carbide Inserts and 4 Pieces Wrench

Worked out great. The inserts held up for what I was doing. No complaints.

I needed a smaller diameter boring bar, but one that would reach a couple of inches longer than the one I have. The small one worked very well. You do need to have or make a tool holder. I made one out of half inch key stock - bored in with the drill in the chuck, and this in the tool post. Then drilled two holes in the side and tapped for a set screw. Works very well. The cutting bits themselves will fit all three boring bars, and are VERY sharp. Well worth the money.

Nice inexpensive set of tools. No frills, no major problems it’s all very boring… One issue I noted working with 316 SS (the only material I’ve used these on) while using either of the 2 smallest tools I did get a fair amount of chatter. I chalked it up to operator feed and/or speed error and switched to the largest boring bar as soon as I had the clearance to use it. These new boring bars and the addition of a small misting cooing system purchased on Amazon as well, my lathe has never turned out better parts!

Cheap tools that work

Great price for the at home hobbyist

I ordered this set, and paid more for it, specifically because it had a depth ruler engraved into the side. I don't have DRO, so this would be really helpful. It is a fine set, but the feature is missing. Every picture on the page has those ruler marks on it, but not the actual product. I needed to do some boring, so I'll keep them. Fine product but some false advertisement.

Great set of boring bars and inserts!!! Definitely recommend worked great on my jet 1024 lathe!! Good price too!!

I'm a hobbist machinist, it does the job, bang for the buck, can't beat it, bad side it's from Chine,