Dorman 76849 Radio Knob Assortment Compatible with Select Models

Wouldn't fit then after reviewing the comments they were correct! The little meal clip inside the original knob has come off and is still on the radio shaft thus...not allowing the new knob to slide on. I took my fingernail and slipped it off the shaft. Perfect fit! Thank goodness for reviews.

Nice factory reproduction

Great value, match and good fit! Just like OEM.

If you still in 2025, drive a 2001 S10 or a Blazer with the stock original radio like me because you're weird like me, you probably have broken radio switches and knobs, if you haven’t changed them out yet.My Eq knobs and tune knobs all started cracking and falling off the radio recently. They were so brittle and old, I knew I needed some new ones.I bought this Dorman kit to replace all the knobs. These fit just like OEM, and made my radio feel and work like new again.

Update 2020-06-23:After a short while the white mark indicators on the small knobs not being positioned correctly where driving me crazy. I could live with the the volume and tuner knobs, although I wish their color was closer to true, but not the small knobs. I replaced them with these HUSUKU 'GM Original Equipment Radio Speaker Control Knobs'. They install easily and cleanly like factory knobs, they look good, and the white dial indicator is true and fully colored in. To do it over, I'd pay more, purchase these HUSUKU small knobs, and ACDELCO volume and tuner knobs.https://www.amazon.com/gp/product/B07J53DX2B/This replacement stereo knob set for GM factory Delco stereos is ok, not great.For 'Easy to install' this is a one star, lowest rating. All six where extremely difficult to install. I have fiddled with my share of car stereos over the years. I have never had as much difficulty installing something so simple before. I had to take care not to damage the stereo from pushing to hard while installing these, especially the small ones for fade/balance and bass/treble. I found success in using an oscillating motion while pushing in on the knobs. With effort and patience they eventually went onto their respective shafts. One of the four small knobs sits much lower on the shaft then the other three. I believe another review mentioned this. It bugged me so I tried to slide it out some to make them match in height. Once the knobs are in place, they are extremely tight and very difficult to remove. Additionally, the small white indicator lines that are painted on or colored in are done poorly. The white 'fill' was applied poorly and does not completely fill the groove. The white lines are slightly offset from true with two of them offset to the left and the other two offset to the right. It appears that they came off two different production machines and both were slightly out of spec. I considered trying to repaint/fill the grooves properly, but something so simple should install in seconds and be completed. I do not have time turning small projects into larger, time consuming projects.The two larger knobs appear to be made fairly cheaply. They were also difficult to install but not as bad as the small knobs. Once installed they are better than nothing (I picked up my stereo used and it came with no knobs at all) and do not look to bad.I have used various Dorman products over the years. In general they are of descent quality, especially since they seem to stay towards the more affordable end of things. This replacement radio knob set is the lowest quality Dorman product I have purchased to date. But, in the end, they work and are much cheaper than true Delco pieces. If they fail or prove problematic, I will update this review.

Knobs do not fit correctly and will not stay in place.

all fit like was said

Just like new! - Very Satisfied!