Grips,Grip Extender Fits Glock mid/Full Size Model -2 Pack Black

Awesome, inexpensive cure for the annoying cutout on the lower front strap of my Gen 2 Glock 19. Went from hating the grip to loving it! Also working correctly in the front strap cutout of my Keltec SUB2000. I would prefer that this grip base did not have the lower extension for the finger placement. It makes the overall grip longer. However, for all the good that this item does, that is a very minor complaint. You will definitely want the mag base removal tool (also sold on Amazon) for this task. Worth every penny to save the aggravation of removing the Glock mag bases.

These are being used in a gen2 g23. The half-moon cutout is sharp and unpleasant to my pinky finger. I hit it with a file and some sandpaper to radius the edges and purchased these extenders. They add a bit of length to the grip length (about 1/2 inch) but don’t seem to increase my printing. What they DO do is provide a solid, smooth surface for my pinky to curl around when firing. These might not be necessary on a 9mm, but on the 40 S&W they have made gripping the gun under recoil more pleasant. I’ve ordered three pair so far and am ordering two more, because as we all know, things we like will be discontinued or ‘improved’ so that they don’t work anymore. Recommend.

Adds some length to the mag on my G19 gen 3. Snug fit, easy to install, appears to be good quality. Concealed everyday for with this installed for several months and haven't noticed any issues with fit or finish. It feels like it a factory addition and gives you a little more secure grip than with that squared off mag and the pinky dangling.

Hard assembly if you can’t get the bottoms off the mags. Some require special tools. Need to get the exact right one for the right mags.

Excellent product and price, superfast shipping, AAA+++

The grip extensions work fine and the removable tab on top fits perfectly into the half moon opening (designed to allow easy manual removal of the mag if jammed) on the bottom of the Gen 5 grip. I understand Glock has fixed this issue on the more recently manufactured Gen 5's due to many complaints. The problem I have is that the mag moves upward back into the magwell with every shot and my pinkie finger ends up being pinched between the top of the mag extension and the bottom of the magwell. This is no fault of the grip extender but a design flaw of the gun.

This product does not fit the magazines correctly it moves one installed and can be removed by just pulling down on base plate. The magazine will not fit at all it falls out once installed. This product is junk total waste of money.

These units may be made for a GLOCK. I installed them on a Kel-Tec sub 2k with glock 22 mags. The separate radius-ed piece did not sit at the same angle as the mag so I had to remove a lot of material from the back. Also, the radius did not fit in the grip preventing the mag from fully seating. More work. It took an hour of trial-and-fit but I like to tinker. The result is after all these years the grip feels and fits my hand better ! Kel-Tec dose not offer something like this as an accessory. Why? For 10 dollars I made them work. Some one else, with a glock, may rate them higher.