KEMIMOTO XP 1000 Clear Front Full Windshield Compatible with 2019-2023 Polaris RZR XP 1000 / RZR XP Turbo 2/4 Seater,Impact UV Resistant,Pre-Installed Rubber Strip,Hard-Coated PC Replace#2884018

The fitment was what it needed to be. Installation was fairly easy, just keeping the weather stripping in place wasn’t fun so use some black gasket sealer to hold it in place. The hardware it came with worked as it should. Seems to be good quality so far, have made a few trail rides with it and hasn’t got scratched up or anything yet. So far so good. Great buy for the money and looks good.

Good product. It can take a lot of wind that’s for sure. It does collect dust if you’re driving in desert.

First, this windshield worked exceptionally well for the price. Overall the quality was sturdy, and was crystal clear to look through. I was looking for a quick less expensive solution for a SXS trip we took to the Hatfield trails in WV, and couldn't be more pleased. The picture is after I dumped a water bottle over the windshield and just let the mud run off it. Do I expect these results forever? No. But I have no scratches or maring from over 200 miles of rugged trail riding. Maybe I'm just lucky, but I would totally buy again and have recommended to others already. It didn't come with any instructions, so I did initially put the gasket seals on upside-down. But that was a 5 minute fix.

The KEMIMOTO Front Windshield for Polaris RZR XP 1000 does not fully fit the complete front opening. There is a 1” gap either at the top or bottom depending on placement. I went for quick shipping but ended up with a cheap product. What is the purpose of a full windshield if it doesn’t fill the full gap? Don’t buy.

Easy to install, great for keeping dust and rain from hitting you in the face. Fit 2020 rzr 4 seat perfect. Good quality had it on a couple months and very few scratches in it.

Seal hard to fit but worth it. Had it on some country roads only problem should have bought it sooner.

Aside from installation struggle I dealt with due to aftermarket roof, and LED pods on bottom of roll cage, and side mirrors, it was extremely difficult to push the tie strap through the window clamp and I needed a pick to pull it through enough to get with my finger. The rubber seals could be improved. The bottom (wider) seal looks very stressed and may not block much wind due to kinks in corners. Couldn't use the top seal without removing roof. This may be good for a stock setup or just needs better parts for installation. I'll give it a try before I decide to return.

Could use instructions on at least what piece of rubber goes where.