OMT Rear Axle Bearing Puller, Rear Axle Bearing Remover Set

Ignore the negative reviews about these they work as intended with a compatible slide hammer. The only concern I had with this tool was that the pins that hold the rocker in place that pulls the bearing are not seated properly or at least on the set I received were not. I was able to pull both rear axle bearing out. However upon removing the second bearing from the tool the pin on the rocker had partially popped out. I fixed this by using a flat punch and hammer to make sure it was back in place properly. Also make sure you have a compatible slide hammer. I assume I’m not the only one who has experienced quality control issues with this product overall happy with my purchase.

Put up with 5lb slider hammer and some hard to remove bearings. Bearings wouldn't budge before I tried this. Worth every penny. Be sure to snug the bolt down, give it a wiggle and check it is still snug. Easy to use. Quality is par at least for the home mechanic. I wouldn't do another axle bearing without this. Made the job much easier. Worked good for me, and reduced my effort. Still I would use a good slide hammer with a decent weight slide. 2014 Ford Raptor axle bearings with 100k miles of rough terrain for reference. Before the tool, tried old fashioned triple claw with no progress. After this tool, the job is done. The example above is so you know it wasn't an average job. You may sweat a little, but it will still be less than without the tool. Glad I have this set in my toolbox.

Good tool, it does exactly what it should. Check out my video.

It worked on my van! I was worried it was cheaply made but it worked!

I "assisted", meaning I did most of the work, in replacing an axle on a dual-axle utility trailer, which I do not own. This is a nice tool set, and it appears to have everything I will ever need to do what most DIYERS are capable of doing. I have a keytag that says "I fix things, and I know stuff", and it was given to me by the person who had the wrecked axle. He was happy, and I'm done with this review. If you buy it, I doubt you will be disappointed.

👌

They are high quality pullers, well made and can take a lot of impacts, unfortunately my rear roller bearings were seized up and just too difficult to pull out with a normal slide hammer kit. I think for most normal bearing extractions they will work just fine.

It's pretty good but the washer did break during the first use. I think it’s worth buying if you have a good slide hammer.

Excelente para suspensiones y baleros de rueda. Automotriz.

I don’t usually take the time to write reviews, but this tool definitely earned one. Going into this job, I honestly wasn’t expecting the best results. I was dealing with a stubborn axle bearing that was completely stuck, and I had already tried a few other methods. Once I got this puller set up, it completely changed the game. I put it through a pretty tough test, lots of solid hits with the slide hammer, and it held up extremely well. No slipping, no bending, just did exactly what it was supposed to do. In my case, the combination of the welding trick, a bit of heat, and this puller was the only way I was getting that bearing out. Without this tool, I’d probably still be fighting it. Really impressed with the durability and how well it performed under pressure. Definitely worth having in the toolbox.

Fast shipping

Todo parece que es de buena calidad y espero me sea muy util ya que aun no lo utilizo

fantastic kit if you already have a slide hammer. used the kit to pull and replace 67-72 c10 12bolt axle bearings. easily slipped in and pulled out the first side in a minute or so. second side was siezed from rust more, and took 20 slide-hits, but made it no issues. 10/10. solid build, no wear and tear on the first pulls, not worried about bending like some cheaper steel out there.