3D Backgrounds Frame Metal Cutting Die for Scrapbooking, New Cutting Dies DIY Album Card Making Decor Paper Craft Metal Die Cuts Party Wedding Decorations (Flower A 3.9 x 2.5 in)

Awesome die, cuts well. It took some playing around with the different pieces to get the desired effect but it was well worth it. Have been making cards for 25 yrs and this is my favorite die of all time. Makes some gorgeous dimensional flowers!

This is a lovely die. I made a birthday card that turned out so pretty, by cutting and using an inked damper to give it a watercolor effect. The result was delicate and beautiful which could be arranged on the card in different ways.

I have a hard tie getting all the leaves to cut. The majority cut fine but 2 or 3 on the branches don't cut until I add several shims and then it's hard to turn my Amaze cutter to go over it. Also they are too thick to use my regular AB and C plates so I have to use shims with A and B plates. Kind of tricky. And it's hard to remove the branches; they are so thin and have no way to poke them from the back. . When using these for a class of 8 I have to cut the leaves in small batches as it's too difficult on my hand and arm. I love the leaves though.

They're calling this die a sunflower but it's really a cone flower. This is a 7 piece die set - 5 pieces for the flower and 2 leaves. No instructions but it's easy to figure out the layering. It cut beautifully and made a beautiful flower, approximately 2 1/2 inches wide by 1 1/2 inches high. Refer to the photos shown on the Amazon page for ideas of coloring. Very happy with this die.

Cuts well, enough leaves to create a nice floral piece without a lot of cutting

These die cuts are cute. They didn’t cut through well so I have to run the through my Sizzix Big Shot a couple of times. It is also difficult to remove the paper from the think parts of the die cut. Other die cuts I have have “poke holes” to make paper removal from the die cut easy. Unfortunately, these do not.

What I like about this die is I can cut the finished product to make varying sizes and layouts. I don't always have to use it as its intended at full length. it does take patience and careful separating from the die itself because it's very delicate. I'm quite pleased with this vine die.

I’m working on using this die to make sympathy cards. If your die cut machine is in good condition, only run the die through once. If more, the flowers may cut off the stem. I plan to buy adhesive sheets to use with this die rather than using wet glue or a tape runner.

Made this greeting card using this set of die’s.

Cuts for the most part, middles aren't great. The centers are very very small. But beautiful when you put it all together!