DC 5V USB COB LED Strip Light Cool White 6000K IP65 Waterproof CRI 93+ USB Powered 6.6ft/2M 640LEDs High Brightness Flexible LED Tape Lights

I like this light as it is very bright blue and so far has worked well. It would have been nicer if the cable was a little longer, as it has a USB connection so getting it plugged in was a bit of a challenge. Also, I would not put this in a child's room unless the actual strip is somewhat hidden. The light is extremely bright and not sure how good this would be, full force especially, for a kid. Mine is under a shelf, when the actual strip is hidden.

Very fast delivery and packaged very well. Very bright color and easy to install

Cut the LED strip in the middle of a location with the copper pads.Remove the silicone cover with your fingernail over the copper pad.Use a razor to scrape off the top layer on that copper. It should lighten up.Put a small bit of flux on this copper surface.Then tin it with a hot soldering iron and you should get a good soldered pad with a good adhesion.Took me a few to figure out I had to scrape down the copper a bit to get the remainder of the silicone residue off it to expose a good copper surface.

Lights work and stick great. Some complain about the strip not sticking, they just wore off the tape. There is clear double sided tape on the back of the lights. When you pull off the backing, make sure you don’t pull off the tape also. Just check it, be careful, and it sticks great.

I used this product for a project for my father in law. The lights are amazingly bright, the adhesive is way better than the cheaper lower quality lights. 10/10 gunna buy again!

These lights are very bright and seem to be good quality. However, the adhesive has a MAJOR flaw, so make sure you read this...When you are ready to apply the light strip to a surface and go to peel off the paper backing, make sure the adhesive is sticking to the light strip and NOT the paper you are peeling off! This is very difficult to do, because the adhesive has a stronger bond to the paper than it does to the back of the light strip, and once you peel the paper off, there is virtually no way to get the adhesive back onto the light strip. My recommendation: don't start peeling at either end of the strip. Instead, find a place along the strip where the paper-backing is buckling and sticking up. Then use the tip of a knife to cut the paper and carefully peel away the paper from that spot while making sure the adhesive is on the light strip. If you do this, you're good to go. Good luck!

Had more of a orange hue to it than red I’d say getsWarm too..

Nice led cob strip very bright on high and dimable