Blank White Surface Magnet Sheets,24 Inch X 10 Feet, 30 Mil

I used this magnet sheet to conceal an ugly, rusted water heater cover in a bathroom. The tank itself is enclosed in a white metal box, kind of like a washing machine and would have been impossible to replace or paint, but this magnet sheet made it look brand new! It was very easy to trim with scissors for a perfect fit and magnet was very strong. Some of the rust bumps showed through, so it could be a little thicker, but it definitely improved the look of the appliance. Very happy with the results!

I purchased this under product under the impression it was suitable for sublimation. After receiving it and cutting multiple test pieces and attempting to sublimate on it, I learned it's not. Complete waste of money and not useable for me.The magnetic magic is also lost so the thing barely even sticks to anything.Can't return because there's quite a bit gone, but completely worthless product and a complete waste of my money.

Can’t speak for longevity yet but I had to combat many of the poor reviews. I bought 2, 40mm 5 foot magnets. I only use them to place on the doors of a wrapped vehicle.I took them out of the packaging, stuck them to the side of my deep freeze in the garage and let them stay there for about 24 hours. No warping, no peeling, no imperfections on either side of the magnets, no peeling, stuck to the freezer as expected.Cut both 5 foot runs into the 4 pieces I needed, applied to the vehicle and they’ve stuck fine, at speed. This is on top of a wrap, which will degrade the magnet force, and they still stick perfectly.Hopefully this helps someone. I saw a bunch of reviews about warping/not laying flat and that they wouldn’t stay on a vehicle. My experience is the opposite. I run my magnets for a couple years (in TX heat and cold) then replace. I’ll be buying again (if they’re still selling them in a couple years).

Very well

The magnetic roll arrived with multiple sharp kinks that appear to be permanent deformations rather than simple bends. This type of damage typically occurs when the material is not properly supported, and it significantly impacts performance.As a result:• The material does not lay flat• It produces visible defects when printing• It is not suitable for applications like magnetic signage, especially for vehiclesDue to these issues, the product was not usable for its intended purpose.

The first 15” of the roll was not magnetized. So it was waste for my project. The rest worked fine for what I needed.

I used this make a cover for the cowl vent on my truck to keep water and insects out. It does the job very well, but the material seems a bit brittle. I remove it often, so it may just be my use case that exposes the issue. The magnetic strength is perfect: it stays on even when I forget to remove it and drive away but it is easily lifted off.

I trimmed this to cover heat/ac vents in my office at work and they do a wonderful job. They stick well, blend in with the wall, and are easy to move. They were easy to cut with just a normal pair of scissors and flattened out pretty quickly from being rolled. They've saved me from being cooked by my building's overzealous HVAC system.

Doesnt even stick to the door of my truck. Horrible product, do not buy

If I could give zero stars I would.Bought with higher expectations. Came in a flattend roll.I have had it laying out for 3 days. Still not flat and has divots in it. Will be returning. Will not work for project I need to do.

I really needed this product to work as advertised and was so disappointed. I suspect somewhere along the way it lost its magnetic properties and the seller is unaware the product is now defective.

It is not magnetic and does not stick at all