Door Panel Pull Handle Set Compatible with Beetle 1998-2010 Aircraft Grade Aluminium Black 2 Handles with 4 Screws

Better than expected, looks great and should last long than the car. It helps hold door panel in place as well. Nice upgrade

I’ve been pulling my door shut buy the mesh net compartment for years while looking for replacement panels which were either non existent or cost several hundred dollars each for worn out wrong, color panels that may break like mine did. I service VW’s for a living and know that with age this problem is fairly common. My car has 285,000 miles.I had happy to see this repair kit offered on Amazon but waited a year before spending just under $30.00 for the pair. Now that they are in place I regret waiting. This repair kit is reasonably priced and well manufactured. They are aluminum flat handles and include two spacer sleeves and two extended length hex head strews. The before and after pictures tell the story. Total time invested was under 15 minutes.The handles usually don’t break off flush so some trimming was necessary with a dremel tool. Without one a razor knife or cutters could be used instead but not recommended. After trimming the high broken pieces the sheaves are placed into the round slots, the handle held in place and the two screws installed and tightened.If your New Beetle handles are broken do not delay. Purchase a pair of these well made good looking replacements.

They work for what I needed. I just got my first car and oh boy it's a fixer upper. So I got these to help with that. Lol it fits well enough. And it looks nice. But careful they can feel a bit less or lacking in feel. The edges are no joke either. I always feel like I might either cut myself or break a finger smacking my hand into them. Other than all that they work and look Kool.

The handle has a bend to it that the replacement handles don't. This makes install kind of a pain.Be prepared to file down the latching bits for the old handle to make this one fit correctly. Have a clamp handy to hold it in place. Get one bolt attached just enough to hold, then move on to the next one. Use the clamp to help introduce the slight curve you need, then get the second bolt attached. Tighten each a bit and go back and forth until you are fully attached. This is what worked for me.Once installed, these are bulletproof. Excellent quality and look great.

Easy to install and works great now I can close both my doors !! I have a 2001 beetle

You have to completely remove old handle carefully before installing this product. I used an oscillating multi tool.

They fit perfect.

They are exactly what they say they are, but they do not fit around the original handle unless you ripped or broke that already ended up just bending in the vice some and installing at least I can close and open the door now.These are flat and not curved

Me encantaron! Le dan un toque especial y ya no se ven feas las puertas , el carro venía sin manijas pero así ya no he batallado y súper resistentes

If you want to use these you need to trim the plastic inner handle pieces flat to match the flatness of this product. Most of this aftermarket ones seem to be sold like this but I found a couple on eBay that match the curve without trimming. I’m probably not going to install these.