DEEPCOOL AK400 (R-AK400-BKNNMN-G-1) High Performance Air Cooler with Unique Matrix Fin Design, Side Flow Type, Compatible with LGA1700

I had installed my Ryzen 5 5600G CPU with the included box cooler (stealth wraith). After a month of use, I noticed that the thermals were very poor, with CPU temps at 45-50 degree Celsius at 3-4% idle and the maximum thermal limit of 95 degree Celsius at 100% loadClearly this was a problem. After doing some research I came across a gamer's nexus (youtube video channel) video recommending the Deep cool AK400 as a very good budget cooler, so ordered the same.Installation was really easy. I was able to remove the stock cooler while the motherboard was still in the case and put in the cooler and close it up. Took me about 30-40 minutessomethings to remember:-the stock cooler can get stuck to the CPU, which means while removing the cooler, it is possible to yank out the CPU with the cooler causing damage (AMD AM4 only, intel does not have this problem)-To avoid this issue, run a CPU intensive test like cinebench for 10 minutes, then switch off the PC, disconnect all the cables and unscrew the four screw holding the cooler. Do it in a criss-sross fashion, little by little, one screw at a time-Once all screws are out gently twist the cooler left and right until it comes off. clean the paste on the CPUThen follow the instructions in the package to do the installation. The cooler comes with thermal paste pre applied. No need to remove cover note that this unit has a pull fan, meaning it draws air into the fin stack which is then sent out through the rear case fanThere are videos on youtube that show uninstall of the stock cooler/ install of AK400 for AMDthe cooler itself has 4 copper connected heat pipes which direct heat to the fin stackThis cooler will not fit in most ITX builds as it requires 15cm space to accommodate the heightNow for performance. With this fan running the temperature is 38-41 degree Celsius at 4% idle and a whopping 76 degree Celsius at sustained 100% load. A 20 degree drop in temperature over stock cooler

Yo, en mi caso, lo instale en un ryzen 7 3700x sustituyendo el Wraith Prims de AMD. En juegos con el Rust o Tarkov que son CPU demandante, tenía picos de 80Cº y normalmente se mantenía en 75. Si es verdad que el procesador es calentito, pero no tanto. Desde que puse el disipador nuevo (AK400), la temperatura paso a ser de 48-50Cº; es decir, una mejor de más de 30 grados. Solo puedo decir que impresionante, lo recomiendo

For me this cooler is sufficient but maybe for you it won't be so always watch plenty of reviews and videos on YouTube, reddit, Google before buying anything.4 stars because no extra thermal paste in case you ruin the pre applied one.

安価である程度の冷却性を求めるなら、これでしょう。可もなく不可もなく価格優先なら是非。

Pra quem procura desempenho com custo baixo esse vale a pena.. Tenho ryzen 5600 e estava trabalhando em idle por volta de 54 graus.. apos instalacao fica 40 graus.. E nos jogos nao passa de 55/60 graus.Instalação dele é bem fácil e rápida, nem olhei o manual existe alguns vídeos mostrando como instalar.Uma observação, quanto ao tamanho se tiver gabinete pequeno tera que deixar sem a tampa lateral, no meu caso sobrou cerca de 1.5cm para a tampa de Vidro, no limite do espaço.Uma opção semelhante devido ao espaço é o AG400 que possui o preço um pouco abaixo do AK 400 e tem cerca de 3cm a menos. Escolhi o AK400 devido ao design.No mais um ótimo coolerbox, pelo menos para o ryzen 5 5600 melhorou muito a temperatura.