Motion Pro 90 Degree 1/4" Hex Driver Carb Tool - With Bits

90 degree, compact head width, long reach. This is perfect for that screw (or nut or small hex head screw) that you can see but not reach. Well made tool.

I dont think there is another motorcycle with more carbs than a Valkyrie so you need a good tool to adjust them. After reading reviews, I initially purchased another tool that didnt have exposed gears. That tool may work if you dont have a tight area but for my Valk it did not fit. The low profile of the MotionPro worked great though. I recommend taking out the detent spring and ball but thats person preference.

Had a shower drain that had to install from the top and needed a way to turn a sheathed rubber fitting hose clamp screw where no room for hand or regular socket. I used this tool once for $80 and was 100% worth it because a) only tool that worked out of 1/2 dozen ratchet, flex head, flex drill combos and b) if couldn’t use a tool would have spent actual thousands of dollars to access any other way via lower floor cabinetry. Well built tool. Worked like a champ.

This carb tool is very well made and saved me from having to remove the carbs on my goldwing. Its a bit pricey, but is well worth the money just in time saved while also ending carb tuning frustration.

I almost returned this tool because it was hard to turn and clunky. Turns out there is a ball that clicks into place every 1/8 turn. After trying to adjust the pressure on that, I ended up just removing the ball and now the tool spins freely and more precisely. Yes, it was right there in the instructions, but who bothers to read those? :)

Love this tool!!! Don't need to keep taking off my carbs to adjust them! After cleaning my 4 carbs on my 1980 Honda CB750K I bench synced them and got them to okay. This tool come in perfect when I needed to adjust them when they were on the moto. Recommend it! Would buy again!

Bevel gears fit and finish are so poor the tool binds and locks up. All the bling of stainless and anodized aluminum mean nothing. The gears are a ruff casting and the out put gear has a riduclous amount of end play. THERE IS NO WAY I CAN HAVE ANY CONFIDENCE WHEN SETTING MIXTURE SCREWS.Waste of money !

Cheaper than the motorcycle shop. Great tool. You dont have 2 take the entire motor apart to get that 90 degree screw off. Saved so much time.