16 Oz. Clear, Protective Coating for Metal

It works well I have a metal front door that was extremely sun damaged and paint was faded. This brought it back to life looks almost new. Highly recommended but wear a respirator as this stuff is strong.

This stuff is amazing! Really protects your brass. We use it on hand hammered brass ceiling tiles & also use it on anything brass. Adds a layer of depth to the finish as well! Also retards tarnish. Haven’t tried it on copper yet.

This stuff is expensive but it sure works as advertised. Brushes right on with a brush or foam brush, then lays flat and smooth. Dries to a smooth, non-sticky, glossy finish. I'm impressed. I was going to put on like three coats but I ended up only using one coat because it seems to make a nice thick layer. Seems very protective. I look forward to seeing how the bare metal parts that I coated with this hold up over time. So far they are not showing any rust at all. Thanks Everbrite!

Important to clean and prep. I applied to a brass wind direction piece which is located outside. So far it's holding up and looking good. I applied with a small foam brush and applied two coats allowing 24 hrs between. Easy-to-use.

We have powder coated brown fences and gates. We live in South Florida exposed to the salt and extreme heat . Over the past few years we noticed the fence and gate lost there luster . We applied Everbrite and they look like brand new. I was amazed at the results. Cannot be happier !!!

This is the 2nd time I have ordered this product; trust me a can goes a long way use sparingly the end results are unbelievable I could not have been more pleased with how the end product turned out and i would highly recommend, shipping was fast smell not bad to be expected great value for what the product produces w/ end results dries in 24 hours easy to use if you follow the directions if you don't you have yourself to blame for results that won't be what you expected. I could not be happier w/ the decision I made at the request of a former restorer and works very well. Joe

This is an amazing clear coat I use it keep the copper jewelry i make from tarnishing. It's super easy to use and to clean up I will definitely buy more when I run out.

I tried to coat some anodized aluminum square tubing that will be exposed to sunlight. The product can't be applied evenly without streaks, it isn't self leveling. I tried the pad that came with the product and also a foam brush. If looks awful, don't but it. Now i have to take the coating off with acetone. What a waste of time and money.

I used this on some barn steel. I wanted to save the rust and make it all look shiny and prevent it from rusting further. The product is easy to work with and it looks great. It has a wet look and and the rust pop.

Works great, dries even with no streaks. Applied over a month ago and no sign of tarnishing on my copper cupola, still brite and shiny.

Definitely brightened up the window frames more so on the north and west of the house where the sun has less chance to dull the color as for the east and south the frames were much more faded so the appearance had less improvement but is now protected. The product is very easy to apply.

The product was fine .

My garage doors are 15 yrs old. This product has brought them back to life. Very easy application with a sponge. I did 2 coats. On the picture, the middle door hasnt been done, just to show difference. I highly recommend Everbrite.