Tail Brake Turn Signal

These little guys worked great. They're much brighter than expected.They're also a little smaller than I expected, but the dimensions in the ad are accurate.They have a 'start up' pattern that occurs once upon initial turn on.The brake light blinks 3 times rapidly, then comes on bright until the brake is released.The turn signals are close together, so a little hard to distinguish, but work fine. They have built in 'on/off' circuit that is active as long as voltage is applied. My scooter runs on 60v and this light works great. I bought two because if they weren't bright or large enough, I was going to mount one over the other, doubling the area.I didn't need to so now I have a spare.

Great light at a great price! The sequential animations look awesome and the look is unreal. So cyberpunky! The quality feels good, and the wiring is really easy.You’ll have to figure out your own mounting, but these days with 3d printing, it’s pretty dang easy. I 3d printed my own mount for my CB 750 cafe, and I could not be happier.Just make sure your battery is running strong, the micro controller inside the light will not turn on unless it is over 11 V It seems like.

I used quick clamps to there was no splicing. I love the fast strobe effect before the brake shows solid, andbrhe flowing turn signals. Wouldn't hesitate to buy again!

Lights are pretty small but they are bright. I wired them on my ebike so they are always bright like if i was hitting the brakes. Cars will see you at night and day with these little lights.

I was a bit worried the amber for the turn signals wouldn't be visible enough during the day, but it really pops, and the red for the tail/brake light is crisp and clear. It feels a lot more solid than the stock plastic ones I replaced, and the dual-color functionality makes the back of the bike look much cleaner and more modern. Installation was straightforward since the wiring is simple, and for the price, it’s a massive safety upgrade for better visibility on the road.

I used these lights on my bike rack,my electric bikes block the lights on truck so,I put these lights on and now I know they can see my directional and break lights.Worth every penny !

If your gas motorcycle or scooter runs the headlight and tail lights off the AC generator, this might require some creativity. This light needs 12v DC, so the tail light didn't work until I found a source of 12v DC that runs when the ignition is turned on. I knew the turn signals and horn work when the motor is not running so they run off the battery, so I connected a wire from the 12v source at the turn signal switch to the tail light wire and now it works.

Super bright. Very nice. Definitely can see during the daytime. Nice style. I love. It works great.

as advertised. Easy mount, long wire run, and easy termination. Great product for the price as a second rear lamp on a motorcycle.

Very cool but hard to connect to my bike. Then I try to another wire to connect. Yes it s working good thank you . I recommend to any customer to buy this product

12-80v. Four wires for each function plus a common ground.-Light on ( initial animation )- brakes (initial flash)- left indicator (animated)- right indicator (animated)-left and right powered together are synced if you want hazards

Works well, so far for a month or so. I like the start up sequence as well as the quick flash brake light to grab attention.

Wiring was complicated, but figured it out on an hour. Works perfectly and it's beautiful