PSLER Quick-Release Shovel Axe Mount Clamps for 1-1.75'' Roll Bar Roof Rack

I used these clamps to mount a shovel to my RZR, and they do the job really well. The rubber is thick and holds tight once you get it latched. It was a little tough to clamp down the first few times, but that’s probably just the rubber needing to break in. After a couple uses, it’s already getting easier. Once locked, the shovel doesn’t move or rattle, even on rough terrain. Exactly what I wanted — simple, sturdy mounts that keep gear secure. Would definitely buy again.

Works great, mounted on sxs, hold shovel in place well. Only issue is mount the on the inside of roll bars. Ripped one of them.due to mounted on outside of cage and caught a tree

Perfect mount for the shovel on top of my Land Rover Discovery

Moderate cursing while installing it. Stuck it on my rack to hold a wee shovel. The Allen key that comes with the kit is soft as butter. Use a better quality one. It doesn't hold in place very well, even with the extra sticky rubber tape they give you. It's not like the shovel is heavy either. Back the the drawing board

I ordered this to install a shovel on my RZR. This was easy to install and not too big. I have taken it on multiple trail rides with a shovel installed and the mount has held up. Would recommend if looking to use it on a RZR.

Worked very well. Holds well

this is a must have if your in the sxs world to hold just about whatever to the roll bar . I use it to hold my Milwaukee chop axe.

Does exactly what I needed it to do.

Super produit tres bonne quality jadore

Bought these to mount a shovel on the ladder of my truck camper. It was no problem figuring which combination of shims I needed to mount it. There were enough extra shims to use on both sides of the mounts. Mounts solid, next winter will be the test.

Looks good and feels well built! We'll see how it holds up this summer!

Lower quality material doesn’t really stay in place even at tightest setting it will fall with a shovel on it.

If you want this for smaller tools or smaller dia objects beware the clamp will not hold them tightly. The advertised size range, while firstly being expressed in very odd fractions, is also not accurate. Saying this can grasp "1 1/7" shafts is incorrect. 1 and 1/7th of an inch is about 29mm yet this wont even clamp down on a 32mm shaft. Very odd dimensions so beware if you have smaller dia objects. Im sure its fine for larger ones..... Quality isnt bad but the description is poorly worded and wrong