BOSCH 0261230208 OE Boost Pressure/Manifold Absolute Pressure (MAP) Sensor

This was the right part, make sure you look at it very carefully and double check part numbers. As I stated this was the correct part Thank you

This Bosch part was an exact match for the MAP Sensor (aka Boost Pressure Sensor) on my 2013 Audi A4. Even down to the various numbers and letters molded into the plastic housing. I am convinced that Bosch makes the sensor for Audi. One morning my car stalled a couple of times when trying to start. Then started, but ran rough, was clearly in "limp" mode, and the ECS and Check Engine lights came on. I used my Ross-Tech VAG-com software and dongle to pull the error codes and found P0234 "Limit Exceeded (Overboost Condition)", P0238 "Signal too High", and P0236 "Implausible Signal". I cleared the DTC codes and started the car. It still ran rough and was clearly still in "limp" mode. Only the Check Engine light was on this time. When I pulled the codes again, there was only P0238. So I suspected a failed MAP sensor. The Audi part is $111 MSRP and can be had online from Audi dealer for about $85. I figured for $24 this Bosch part was worth a try. After installing the part and starting the car, the Check Engine light was not on and the car seems to be running fine again. The MAP sensor is located on the drivers side in the engine compartment near the headlight. It is mounted using Torx screw onto a 2" diameter plastic air conduit which is downstream of the Intercooler (not visitble). Attached downstream of this plastic air conduit is a fat hose that clearly moves air up to the top of the engine. Replacing the MAP sensor took 5 minutes.

I just replaced the OEM MAP sensor on my 2012 Audi A4 with this Bosch sensor. I’ve only driven one time since I installed, but it seems to be fine. I think it will be a great choice because Bosch is a great brand.

Ok

Exact match

Perfectly fit on my seat ibiza FR 1.4tsi. It had check engine light on and felt terrible like bad spark, and plug the vag com cable, knew was this and simple 2 torx dissambly plug and ready again. No check engine again.

don’t fit audi 2014 2.0t

How to check engine light on my Audi A4, and this sensor cleared it all up. Bosch is a reputable company, hence the reason I trust them for all of my car needs..

Bosch es calidad

Despite Amazon saying it wouldn't fit it did. The part number supercedes the old one. No engine codes and I can see boost on my scanner.

Installé en deux min, ma Audi A6 1.9 TDI de 2004 n'est plus en "limp mode" (le code d'erreur P0237 ainsi que le voyant moteur ne reviennent plus une fois effacés à l'aide de ieGeek OBD WiFi OBD2 Mini Adaptateur et l'app OBD Car Doctor free). Le produit semble de très bonne qualité.

Conforme a la description

bon 100% fonctionnel dans ma voiture