7" Touch Screen, Replacement 4-pin Touch-Screen Glass Digitizer Compatible with Hyundai Sonata Veloster Kia Radio 2013-2016, for LB070WV7 (TD)(01), for LMS700KF30 TM070

Easy to install, when you watch a couple of videos, and the result is perfect. The cable is wider at the base, but plenty long to accommodate the rerouting. My touch screen is working again!!

Used to replace the screen on a 2014 Hyundai Veloster, fairly simple to replace and it works perfectly. The fit isn’t 100% as there’s a small grey line overhanging on the left side of the screen which I also noticed on others reviews (the screen itself was 100% perfectly centered when being put on) but it’s just a cosmetic issue, doesn’t affect the function whatsoever. I’ll take a slight cosmetic misalignment and cheap repair than a non functional screen any day. Highly recommend this product, anyone can do it just be organized when disassembling the radio.

This is nearly a plug and play replacement. A decent DIYer with electronic or car repair skills should be fine. There is a step by step video on YouTube. This replacement is exactly the same size as the original. The 4-pin ribbon that connects the screen is in a slightly different spot than the original and it is longer. I found that routing it up and over the edge was better than routing it through the slot the original cable used. There is a screw in that area, so you will need to push the ribbon aside when reattaching. Not much of an issue. There is a step by step video on YouTube on how to replace the screen. The trim is hard to pull off than all the Veloster videos show. But the trim is attached with snap type buttons rather than edge tabs. So you can be more aggressive than you think pulling it out. You will need to cut away the old screen and there will be some black sealant left behind on the screen. This can be peeled off like tape. Use your razor to scrap all the way to the metal then peel. (Don't let the razor go over the screen. Stay on the metal edge). The new screen has an peel off adhesive. Make sure you have the right side of the new digitizer facing out. The taped (adhesive) edge side goes towards the screen. The black side of the 4-pin ribbon will face towards you (away from the circuit board). This should just fold over without twisting if the screen is installed correctly. Don't forget to peel away the protective film before installing.

This worked on a 2012 hyundai veloster with the dimensions audio system (radio model number LNC1700ENFS (the radio is part number 96560-2v700) the ribbon is slightly longer and in a slightly different place but this was really easily handled. My radio is back to working perfectly! The touch screen which had worked intermittently then stopped working entirely is back to full function for less than $20 and some time on a day off from work.

Very good product! It is already installed & working on my Veloster 2013

works for my 2012 hyundai perfectly！

Works perfectly as long as you're willing to take the whole machine apart to save a lot of money!

Fixed my touchscreen in my 2012 Veloster. Challenging to install but if you take your time it’ll work out. Definitely need some technical know how.

This touch screen is perfect compatible to Veloster 2012 . Little bit difficult to install , but it's worth that