TRQ Driver and Passenger Side Headlight Assembly Set Halogen for 2007-2014 Toyota FJ Cruiser

Very nice set. OEM quality. Easy to install, no fitment issues. Overall great product

Very nice lights. Added looks and good lighting

If you need headlights for a 1995 ford ranger these are the ones you want ! I bought a cheaper set first and the guides that slide in were way too tight to install. This set slid in snug but no fighting it ! Also they are crystal clear lenses even though the current pictures they have make them look smoked. GREAT PRODUCT!!

The headlights I ordered were said to fit the year and model of my van (1999 Ford E350 Club Wagon). The overall shape of the headlight required removal of a bezel that previously went around the existing headlight. No problem. New light did fit in that opening. However, these came with no installation instructions. Once I removed the bezel, there were three mounting holes that seemed to be where you placed the two screw in fasteners and one guide. That matched up but tightening the screws down did not ensure a tight fit into the mounting holes. In fact, tightening them down did nothing. So much for “easy to install”. I ended up making it work by removing the tightening lugs and using them, basically, as nuts. This method does not allow for any adjustment for angle or pitch as I am only able to securely install the headlight by tightening down as much as possible so they don’t wobble about. Ok. Then, the light bulb, as others stated, did not match the wiring harness on my van. I ended up having to locate a plug on connector that matched my new headlights and splice on a male end of the existing wiring harness to make them work. I got power to them but, because of the complete lack of instructions, my wiring seems crossed somehow. My high beam light stays on constantly and the position of high and low is reversed so that in normal running mode, the high beams are on. If I put it over to high beams the lights dim. This product looks good but is seriously poor in every other capacity. I would not buy from this company again and I would caution others to do the same.

Relativity quick and easy install. The fit and finish looks just as good as the factory ones I replaced. It did come with ALL the bulbs pre-installed, but I opted move the supplied low beam bulbs to my fog lights and, since they were only 2 weeks old, I reused the Sylvania Silverstar bulbs I previously installed in the factory assemblies. Long story short, its been about a month of daily driving to and from work in winter darkness, and all the bulbs they supplied are still going strong. For those of you aren't the fix it yourself type, you CAN do this yourself! You WILL have to disassemble parts of your front end, but there are tons of videos online to show you step by step, and what tools you need for your specific car make and model. Before you start your install, I do recommend you go to Harbor Freight and buy yourself their "Automotive Plastic Fastener Kit, 240-Piece" It costs about $18 for 240pcs vs the arm and a leg the auto parts store charges for a 2 pack. If you're vehicle is old enough to need new headlight assemblies, it is also old enough to guarantee that almost all of those little plastic connectors will break as you remove them during the install process. The only con was me not getting new fog light assemblies BEFORE I changed the headlight assemblies. Then I could have changed them while I already had the bumper cover off!

Came with all bulbs and easy fit and good value.

Lights are overall good quality and it's nice that they come with bulbs. However, I wanted to re-use my LED's that were in the old units but the metal that holds the bulbs in place is really flimsy compared to the OEM black plastic pieces so minus one star. With that said I had to replace the header panel that was also broken in a fender bender and the brackets that slide down to secure the units would not lock into place. I had to use a small grinder to make the holes a little bigger in order to slide down all the way and secure the lights. Quick tip. If you have to replace the header panel and the lights make sure the brackets lock in properly BEFORE you install the panel. If you don't you'll have to take it all apart and do it again after modifying the brackets.

Needed to replace the headlights on my 2012 Jeep Liberty due to the old headlights being very cloudy, even after trying to recondition the lights. After doing some research I landed on the TRQ headlight assembly replacement. The headlights were delivered on time and are high quality. I was able to quickly replace the headlights and now they look good as new. I would buy TRQ products again.

I got mine today, very quick. The only thing is that it's H13 bulb. Mine were H4, but I can't swap out the socket so I had to order a h4-h13 adapter. Ps; Also being in Australia I'm not sure if the lenses are configured for RHD, will find out when I get my H13 adapter and fit them. Thanks

I put this on my wish list at $117.00 and change. I go to buy it's $145.42. I just got these two days ago and I just checked the price. $152.42. Whose the ''mark''? Me I guess. I could have got them $30.00 cheaper but shipped by reliable Canada Post. NOT!! These don't come with the lower adjusters. Have to use your old one so don't wreck it taking it out. These are part of the headlights as the other two adjusters they come with. Should have given two stars but then this wouldn't get posted.

I ordered and received it on time. However, after installation, I found that one side ambient light is not working. The other light works fine, but this defeats the purpose of buying a new pair. I expected better quality.

Exactly the same as what comes with the vehicle. Have not received as of yet, arriving today.

Good fit, nice, came with H1 bulbs, very satisfied. The snap locators were bit tight so I removed the adjuster screw and exercised the recover on the headlights first, 4 off.