AKNES HallPi TMR Joystick Replacement for Switch Pro Controller | Anti-Drift Stick, High-Precision, Long Life & Low Power Consumption

Hat super funktioniert kein Stick drift mehr Einbau war auch recht leicht

So far so good they calibrated better than the gulikits ones.

Bought the four pack as it was only 3 dollars more than the two pack and we have multiple controllers. Switch Pro controller. We had drift on the left joystick but the right was fine so I just changed the one. I have a good solder iron (Weller) and a not so good manual vacuum solder sucker (princess auto). I was able to get most of the solder off with the sucker. Using a very small flat screw driver and a second pair of hands to run the iron over the pins, we slowly pried the joystick off. The main joystick body pops off and then you can pull on the two green carbon rings off with tweezers. Cleaned up the holes as best i could and the new joystick popped in. I had to go back and resolder a couple of pins as part of the joystick wasn't registering but after that it works beautifully. Calibrated and checked the push button under switch settings. Would give 5 stars but only installed today, so don't know longevity. Note: I also just left the motion motors in the lower handle and just flipped the board over still attached.

The hardest part was getting the old joysticks off the board, I used a desoldering pump/solder sucker. No trouble getting these back onto the board. Put these in, and no more drift. I'm especially happy because the controller I was fixing was the Tears of the Kingdom edition. Also, the sticks are just like the originals, so no having to get used to a different feel. These are a very good value.

Kamm schnell an und war auch superleicht zu tauschen wenn man natürlich Löt Kenntnisse hat ist es super easy . Alte raus neue rein Kalibrieren fertig und fertig und man braucht kein neuen Controller mehr .