Air Injection Platinum 10 with Fleck 2510SXT and 3/4" Bypass - AIP10-25SXT - For Iron Hydrogen Sulfide Rotten Egg Odor Manganese

These work great if you have a lot of iron. You will be amazed at the difference. Unfortunately, I'm on my second one of these in 2 years. I had a lower end model the 1st time, so I'm hoping i get a little more out of this unit. From what i can tell from the outside, they upgraded the breather on this one and the backwash cycle is less "explosive" when it starts up. They work great until the iron starts building up inside the mechanical parts of the head. Once that happens you have to pull apart the head and spend another $200 replacing the piston and O rings and cleaning all the parts inside (I'm pretty handy, takes about 2 or 3 hrs). The first one failed again a few months after that cleaning, and i basically gave up on it. It wasn't letting air into the system and building pressure (obviously clogged with iron again). I did replace the breather when i tore apart the head the first time. I also should mention that i do have carbon whole house prefilters set up before it hits the iron eater. Probably could have saved the 1st one with another good cleaning and new filter media (But what a pain in the butt). I'm going to hope this upgraded unit buys me an extra year or 2. I think before you buy, you should know that this system will need maintenance to last. If you have heavy iron make sure you set the backwash for every night to keep the system clean. Setting it at every other night didn't work for me the 1st time. Other than that, very happy with our water.

Best investment I’ve made since drilling my new well 4 years ago. Spent thousands of dollars trying to get rid of the sulfur smell and taste even put a Culligan system on the well with no luck! Hooked this system up and smell, taste of sulfur was completely gone within 30 min of start up!

On the second night this sprung a leak Almost flooded my basement It seems like a good unit but the small 1 inch metal With gasket underneath was loose from factory And there was a braided quarter inch diameter screen underneath that was tubular shaped and cut too long which caused the top Not to be able to be tightened fully because it was hitting the underside I had to trim the screen And reinstall the small gasket at the top that had been pushed aside by the water.