AtomikAlloy Front Steering Block - Replacement Part for 1/10 Traxxas Models - Hardened Billet 6061 Aluminum - Lightweight & Durable Performance - Front Chassis Upgrade Part 3736 - Blue

Believe all the reviews saying they dont fit out the box on the trx metal casters, but only took 60 seconds or less of sanding. Still very much worth it. When I tried them first they were very tight where it wouldnt turn without many pounds of force, which would definitely burn out your steering servo immediately. I took some 80 grit sandpaper on each mounting surface and they fit perfectly now. I wasn't very careful with them, but you could tape off the rest to protect the paint, but I just went for it. They fit great now with less than 60 seconds of work and are 1/2 the cost of traxxas.My sons 60+mph brushless stampede is ready for more bashing! They look so strong, the tie rod or one of the control arms will now be the weak point.

These are extremely well made. They installed easily and everything fit correctly.

These fit just like the originals and are a lot stronger. I race at a off-road track and I kept breaking these and I knew traxxas made some and I was going to buy the traxxas ones till I learned that they were $35. I was dumbfounded that such a small part was that expensive so I immediately looked for a cheaper alternative and I found these. I also have the rear knuckles and have for a while and have never broken one. These are great. The only complaint I have had for any of these products is that some times the bearings are a little difficult to put in and some times they fall out while the axel is out of the hub. That’s the only issue I have ever had with these.

These are colored well and machined well, except the fact that you have to shove them into the Traxxas 3632A aluminum castor blocks. This will not allow for any turning. Shave about half a millimeter off each side and test fit (with the kingpin in!!!) after each adjustment for fitment. They fit the RPM castors fine. I would still buy these again.

They do not fit completely with other brands of casters. They are very tight and require sanding. I’m sure if you couple this with the same brand caster it will fit fine. Otherwise it is a great looking part and made well.

Well made parts, but doesn't work well with Coda Racing castor blocks, I found out the hard way. But, with a little filing to make them fit in the castor blocks, working just fine.

They allow me to do jumps and bumps without worrying about breaking

Great value for the money. Well made perfectly anodized very durable. I would recommend these

Strong and affordable.

Great looking on my stampede.

tres bon

Aok