Feniex Cobra T3 Surface Mount Bracket (L-Bracket)

Years ago I installed Feniex hideways on a motorcycle. One of the heads melted and they sent me a new one.After re-investing the labor to custom install it again... That one melted too. :( I told myself... Never again.I was hopeful that the quality of their products had improved. But this order resulted in me receiving two sets of T3 lights and two license plate brackets. (4 lights, 2 lic plate mounts)As I installed the T3 heads... I noticed that one end of the bracket screw holes for the strobes (far end where hole is for wire to pass through) didn't have any "bite" when you installed the screw for the T3 light. It was completely lose.I thought it was just the ONE lic plate mount. NOPE... It was both of them! One end had great "bite" on the screw while the other will quickly "pop" or "fall" out from vibration. :(Then... I noticed that on one of the lic plate mounts, the tabs where the T3's mount had a "swoop" to it. The darn bracket was bent and allowed the T3's to shoot slightly upwards after mounting. (great for getting truckers attention I guess)Now I have to drive to hardware store and find alternative screws and paint the screw heads black. :( And bend the tabs on one of the brackets to a position that is proper.Not cool Feniex... Not cool!PS: Seller, ordering, shipping was fine. But manufacture needs better Quality Assurance.

Really not much to say its a T3 bracket that swivels.... they mounted right up BUT...…. there is a but t3 lights come with two screws for mounting them to these brackets... Well in one of the brackets I screwed the t3 on not to tight not loose just barely snug not matter what it just wouldn't get tight turns out the mounting holes on the bracket were slightly and I mean hair thickness big thus the screws wouldn't tighten....I would expect feniex to cover all basis one being instead of providing screws to mount it to the bracket they could proven said screws along with a bolt and washer set up even more so knowing vibrations is a screw killer over long term

The holes where the feneix t3’s screw into the bracket are too big for the screws that come with the light heads. I can not find a screw at my local big box hardware store that has a small enough head that will fit in the recess on the t3’s lighthead. Also there is no good way to get the wires from the lightheads behind the license plate without the wires touching the sharp edge of the license plate. Don’t waste your time with this.

Not only are the tabs way too long which appear to be made for the fusion not the T3. But also there isn’t a screw hole for the bottom T3 light to screw into. Unfortunately I was in a time pinch and was unable to return the bracket so I did modify the bracket by cutting the excess amount of material off and drilling a hole for the screw. It was in a sealed package labeled as a T3 brand new.

The manufacturer needs to remember that perhaps wealthy cities and states can afford these but not the average volunteer firefighter can always afford them.....$20.00? Really??

Perfect for the intended purpose.

worked perfectly with purchased feniex lights

Good construction, easy to install