Nutribullet交換用ガスケットシールリング 交換用パーツアクセサリー ブレンダー900シリーズ600Wと900W、デュアルリップデザイン、4インチブレードODに適合、グレーシリコンゴム、3個

Perfect replacement for mixer

They fit my 4.05'' magic bullet blade cup. It is a tight fit so you have to hold it down and stretch it as you go. I used the back of a small spoon. Then press the last inch or so down. It worked perfectly! Arrived early I think too.

Caben perfectamente en mi nutribullet.

My old rubber seal was so gross and I couldn’t get it clean and this new one is great

Good quality, fitting perfectly for Kuvings jars too

Ordered these to replace a worn out gasket in my Nurtibullet 600. I reviewed a few of the gasket options out there especially after seeing reviews about ill-fitting ones. Measured the base/blade component of the blender to ensure it matched the measurements provided in some of the product photos. After seeing so many comments about gaskets not fitting properly I did a quick test with a bit of water and sure enough it leaked right through. In this instance, the gaskets do not appear to be a tight enough fit. I was a bit suspicious when I could fit it to the blade base without much effort at all. From removing my old gasket to clean it, I knew it was a bit tricky to get it back onto the base as it is meant to be tight. Will be returning-don't recommend.