Integral injection molding makes the usage more flexible and the oscilloscope able to adapt more testing situations. Attenuation ratio: 1x and 10x optional. Compatible with domestic and international digital and analog oscilloscopes in relevant frequency. Features: Performance & Characteristics Attenuation ratio: 1× and 10× optional. Portable design according with ergonomics. Integral injection molding makes the usage more flexible and the oscilloscope able to adapt more testing situations. Safety standards: it has passed the CE Attestation of European Community. Specifications: Attenuation:x1 x10 Input resistance:1MΩ: 10MΩ Input capacitance: x1: 85pF-115pF x10: 18.5pF-22.5pF Compensation scope: 15pF-35pF System bandwidth: x1: DC-6MHz x10: DC-200MHz Input voltage: x1:<200V DC +Peak AC x10: <600V DC +Peak AC Weight:55g Cable length:120cm Temperature scope:Operation: -10℃--+50℃ Not Operation: -20℃--+75℃ Humidity: ≤85% (Relative humidity) Application Fields: Compatible with domestic and international digital and analog oscilloscopes in relevant frequency. Measurement in intermediate and low frequency signals. Package Including: Accessories included by PP series passive voltage rapier ● Operation manual ● Adjusting tool: adjusts compensation capacitance to assure the rapier match with oscillograph. ● Contractive-type acuminate hook ● 12cm earth wire with alligator clip ● 3 pairs of colorized cable markers ● Locating sleeve adapts to IC testing.
A**R
Great Price.
This probe was exactly what I was looking for. It is durable and works as expected.
G**R
Works well on small signal measurements
I have several PP-200 probes. They work well on small signals. Used one of these probes to measure the output of my Ham transceiver. The output was 100 volts peak to peak. Worked well on all bands, until I measured the 10 meter (28MHz) signal. The probe immediately failed. Signal was around 90 volts peak to peak. Switched to another PP-200 probe and it failed right away also. So keep the input signals small.
N**Y
No issues
They work great! I grabbed four of these and they perform like I'd expect. Calibrated easily, no ringing from my AWG at 10-30mhz on my 100mhz scope.
E**R
Happy with this probe
Very happy with this probe for my Hantek scope.
A**.
Wasted money
1. I have compared it with original 200Mhz tektronix probes, it is junk - sane not clear and bad bnc contact, it doesn't hold 200Mhz, bad signal already after 80Mhz2. it is not returnable, I could get refund thru amazon helpdesk only, seller did something to put the item in not returnable category.
R**0
You get what you pay for
This is an inexpensive probe for home use. The quality of materials is okay and it works, which is all you can expect of an inexpensive probe. My one complaint would be that it is not easy to fully insert the tip into the clip and you can get a bad connection. It feels like it's fully inserted, but isn't, a little more push and it's good. You get what you pay for.
B**F
Works as advertised
Works as advertised
G**Y
JUNK !!!
These probes appeared to not be shielded properly. I'm not sure which end it was at but the shield on the cables may not have been attached. Hooked to the scope they would trigger a trace by just holding them in my hand and the trace would change with movement.
Trustpilot
1 week ago
1 month ago
