J&D Dual 1/4 inch TS to Dual RCA Stereo Audio Interconnect Cable, Gold Plated Audiowave Series 2X 6.35mm Male TS to 2 RCA Male Stereo Audio Adapter with PVC Shelled Housing and Nylon Braid,1.8 Meter

The non tangle approach is a good one, the red and white identifiers match at both ends, which an ill advised recent purchase did not, so never take these things for granted. The cable is going to get a lot of use plugging and unplugging, but seems quite well made, especially compared to other cables in a similar price range.

Connectors and cable have reasonable build quality. This cable does not have the left and the right sides bonded together, which was ideal for me because my left and a right speakers were a few metres apart. The clips do a good job of keeping together the part of the cable run that I wanted together. The shielding is ok, but a fair bit of noise (hum/hiss) was present, but a 5-metre unbalanced cable run will never be perfect. I used these to connect a source to a pair of active speakers to play loud music for a party and they were totally fine for that.

No issues with this product. I'm using the two of them in the pack to connect the 1/4" jack outputs on a digital piano to the RCA inputs of a stereo amplifier. It works perfectly and the cables seem to be of good quality.

A very good quality strong lead, it’s only negative is it could do with a few more couplers to keep it together

High quality cable and connectors

Order received as described and on time. Good experience.

No complaints. All good

I used this for connecting outputs from a USB audio interface (Behringer UMC404HD) to an amplifier in my home studio to drive monitor speakers.Sound quality is fine as far as it goes, and the cable is well-made with solid connectors. However, I've dropped a couple of stars because there's a big emphasis in the listing on how the cable shields interference. And honestly, it doesn't.I have this running near to, but not immediately next to, a small tower PC, and it also goes near various bits of audio gear (MIDI controller keyboard, digital piano, rackmount synth module, other controllers, microphones, some ethernet cables, and obviously there are power supplies and cables in the area). There's very audible hiss/popping and interference in the signal by the time this reaches the amp. Headphones straight into the audio interface sound clean. Other inputs to the same amp sound clean. So I conclude that whatever the listing says, this cable isn't really shielding very well at all, and I need to replace it at some point.