Mexllex L Shape 4-pin Connectors Angle Ajustable(90-180 Degrees) LED Strip Connectors for 10mm Width 5050 RGB LED Strip Lights(10 Pcs)

As described

These are really useful, and have suited my purpose well. I would say the only problem with these connectors is that each time I cut my LED strip and used the connector, the intensity of the colour/brightness of these lights seems to fade slightly. Otherwise, I think they are great, really easy to use, and work well. I bought them for my Govee LED strip lights to bend around the corners of my walls, which bend at a 45 degree angle in some places. They actually connected 2 5m strips together well, even though I cut and connected the 5m strips multiple times. I used around 5 overall and they seem to have held up well. I'm delighted with the end result.

As I say. They can be fiddly but they do work well.

Work well in terms of connection of rib led ribbon. However the lack of adhesive on them means that they hang down on the corners and add a stress to the rest of the ribbon on either side which gradually pulls the adhesion from the ribbon itself. Had to use a small ribbon bracket either side to prevent this

The media could not be loaded. These are super, we have installed x4 5metre sets of strip lights in our kitchen and on one of the stretches we needed a 90degree bend, after unsuccessful using the ones that came with the lights that piece through fromthe back it resulted in the lights not working past the join, ordered these and they worked super, so pleased as I was worried I had ruined the whole length. Our strip lights had the waterproof stuff over them so we just sliced iff the gel from the top so that the contacts are exposed and slip it into the 90degree join (make sure it is pushed right in underneath the contacts) switched them on and everything was back to working, so much better than the push through joins, would highly recommend

These are the most infuriating things I've bought on Amazon. You think it's going to be easy, just snip the LED strip and clip it into the connector. Wrong. Naive beyond words. There is no 'clip'. Nothing holds them in place and the LEDs refuse to stay lit unless pressed and held in an exact, minuscule spot. Any bump or movement and they cut out. Completely useless and I destroyed my LED strip to use it with these, raging.It may seem like not a big deal but these would actually excel as a torture device or an instant divorce weapon. Just make people have to install just 4 of these and they'll be fit for the mad house in minutes

At last after wasting money on the ones with the rubbish connections with the paper thin L-Shape and white plastic connections these are perfect they do what they’re meant to do. Wouldn’t waste your time buying the other ones I mention above get these they will work and you won’t be wasting your money.

A good idea but I found them to be a bit difficult to get the tape to clip in and took a few attempts to do it,but once it's in correctly it works a treat