SMALLRIG Standard 15mm Micro Rod 1.5 Inches Long with 1/4" Male Female Thread for Clamp Mount - 915

Very well made !!!

Just a little piece to have my gopro a little higher on a stand. Built well and pretty good price.

The media could not be loaded. If you’re just starting out with smallrig you’ll need this add-on extension. It works with all their products. It’s a must have if you don’t order it when you’re getting the initial crab claw or any of the other beautiful manufacture parts from them you’ll have to order it later. My advice is get it while you’re getting everything else. It’s more cost-efficient to have two. I’m just saying that’s what I did. I bought two so you don’t have to switch them from arm to arm part to part. It’s all one working piece. I wish I could be more eloquent and explaining exactly why you need this part but maybe their details about it will say everything I use it in Locksmith. I have a Locksmith channel on YouTube and I couldn’t hold any of my lock cylinders without this additional part. I’m so happy to maybe help you to realize the importance. This is Mike with Door and Lock Tips. Enjoy best of all it comes from Amazon and if you have Amazon prime there’s no shipping hooray for the consumer again this is Mike. Hoping the best in your smallrig adventure. where you will find Quality top notch workmanship ease-of-use with an added benefit of low price.

Well made but won't help with a Theta Z1 camera. Still can't plug in a battery pack. Not enough room because it's too fat and blocks the port. It's a great price though and I'll find a use for it. Just didn't work for my intended use and I wasn't going to return it for $5.

My camera mount was not high enough , so I needed to add a riser and this one filled the bill.When doing moto vlogs I want the camera to be high up enough where I could get my instruments , the forward view and rear view mirror in the frame .Goldwings have a pretty tall dash - in my Vlogs I want to capture a lot of data for my channel on motorcycle etiquette for drivers . Right now I can not afford a 360 camera, so I am using a go pro clone . To get a lot of data on my rides.This works .Ride safe and keep your radar on active scan .

This was exactly what I needed to raise my Canon M50 Camera up on the Tripod in order to have access to remove and insert the SD card into the camera as well as use A/C Adapter while mounted. Worked perfectly. Great product for the price. Would recommend to anyone who needs similar capabilities. 💯%

This is a great little product. There's really not a whole lot to say about it. It's just a threaded piece of metal that you can use with standard 1/4-20 screws. In my case, I'm using it to space my camera correctly on my teleprompter.I bought an inexpensive teleprompter a while back (the Glide Gear model available here on Amazon), and have found two problems with it. First, the camera sits a little bit too low, so when reading the text, I'm still looking above the lens, which defeats the entire purpose of using a prompter in the first place. Second it's difficult to move my hands around the cloth hood to get the camera screwed into place.This little spacer solves both problems. It holds the camera just that little bit higher so that it's now in line with my prompter text. But it also provides an easier "target" for the screw that attaches the camera to the prompter mount, making set-up much easier. What took me a good fifteen minutes to set up before now takes about fifteen seconds.It's a simple little device, but it's durably constructed--I'm not afraid of the product failing and dropping any of my expensive gear. If you have any use for a little tripod extender or spacer, you can't go wrong with this one.

Handy little item that holds no surprises.