I have one remote not working. It will program but the the previous working remote stops working. How can I get them both working.

Hello. You need to pair the 2 remote controls with the receiver. If you do not know clearly about how to prorgram. Please contact with seller firstly, who will help you to solve it. This is a programmable remote control kit. Each receiver can store about 20pcs remote control. This receiver has 6 operating modes. You can program yourself depends on your needs. For example: Please follow the step to reprogram. Step 1 reset Press the learning button (on the receiver) 8 times. The indicator LED on the receiver will flashing several times and then turn off. Succeed. Notice: After reset, all the remote controls cannot work anymore. Step 2 How to program (toggle mode/ mode 2) 1. Press the learning button (on the receiver) 2 times. The indicator LED on the receiver will turn on; 2. Press button "A" on the remote control. The indicator LED on the receiver will flashing several times and then turn off; Succeed. Repeat the Step 2 for the second remote control. So that these 2 remote controls can control this receiver in toggle mode. Thank you.

Can I set up momentary mode on one button and toggle mode on other?

Hello. No. But you can use the mix mode("A" button and "B" button are Toggle mode, "C" button and "D" button are momentary mode ) How to program 1. Press the learning button (on the receiver) 4 times. The indicator LED on the receiver will turn on; 2. Press button "A" on the remote transmitter. The indicator LED on the receiver will flashing several times and then turn off; Succeed. So that "A" button and "B" button are Toggle mode to control relay "1" and relay "2". "C" button and "D" button are momentary mode to control relay "3" and relay "4".

Hello, Ive connected a 12v supply top a 12v light ive wired it exactly as the instructions say and it trips at my fuse board please help

Tripping at the fuse board is probably caused by overcurrent, or a short to ground. Try just touching together the two wires that you want to relay-control, to check that is working, before connecting to the Receiver. The Receiver needs a 12 volt feed from some sort of mains-powered regulator, so make sure that is OK. The screw terminals on the relays, should be completely isolated from each other and the rest of the board ( except the Common and Normally-Closed of each relay ), so try to check the ohms with a meter.

Can this unit be wired directly to 240volt, ac mains? or do i need a transformer to adapt to the input dc voltage?

This receiver can work on DC 6~30V. It can not connect directly to 240V. You need a transformer. The working current for this receiver need to be more than 1A.

Manufacturer	DieseRC
Part number	2404
Item Weight	168 g
Product Dimensions	7.5 x 5.5 x 3 cm; 168 g
Batteries	1 CR2032 batteries required. (included)
Item model number	2404
Size	1 Relay Receiver with 2 Transmitters
Colour	KT16
Wattage	3E+2
Item Package Quantity	1
Plug profile	Surface Mount
Batteries included?	Yes
Batteries Required?	Yes
Battery Cell Type	Lithium Manganese Dioxide
tech_spec_battery_description_toys	Lithium

Sponsored Ad – DieseRC DC 12V 24V 4CH Wireless Remote Control Switch DC 6-30V 10A 4-Channels 433Mhz Radio Frequency Relay Receiver with 2 RF Transmitters for Lights Garage Door Motor Awning

Details

Description

Specifications

Have a Question? See What Others Asked

Common Questions