Rust-OleumTub & Tile Paint 244166 Specialty Kit Tub and Tile Touch Up, White, 2 Piece Set, 0.45 Oz

Just follow the instructions, easier than I thought. They don't mention there is a brush in the B bottle, I found it out when putting the A bottle contents into the B bottle. They mean it when they state it is only good for 24 hours. Sometimes I waited longer than the recommended 15 minutes between applications, sanded down the higher stuff, and reapplied. Overall, it took me approx 20 hours to get it where I wanted it. I might mention that the white color is really white. I like the stuff, it worked!

I used this to repair two chips on a porcelain bathtub. Both were all the way through to the metal so there was rust that had to be cleaned off first. I used vinegar and salt to clean off as much of the rust as I could, then went over it with a little piece of 320 grit emery paper. Next I mixed the touch up kit and applied it with the supplied brush. The brush is small enough that you can precisely match the edges of the patch to the edges of the chip. However, it holds a surprising amount of the compound so (just like with paint) you have to be careful not to load up it up too much. The compound has approximately the same viscosity as correction fluid and I'm guessing would be difficult to use on anything other than a horizontal surface. Fortunately both of my chips were on the flat ledge surrounding the tub. After applying the compound I allowed three full days for it to cure before exposing the repairs to water. The cured product has a smooth finish, similar to the porcelain itself, although it is raised slightly above the surrounding surface. I suppose if you were really OCD you could do some wet sanding to achieve a perfectly level surface, but I didn't bother with this. So far the repairs have survived two long, hot showers and seem to be holding up well. The only thing preventing me from giving 5 stars is that the color match is not perfect; the compound is somewhat whiter than standard bathtub porcelain. But unless you look closely, it does not jump out at you.Once mixed, the compound must be used within 24 hours, so make sure you identify all needed repairs before beginning.

I dropped a glass lid on the edge of my refinished claw foot tub. It left a couple chips in the finish. I had used the full size rustoleum epoxy kit originally and it worked great and left a beautiful glossy finish. So I ordered the small repair kit and you can hardly tell where it was repaired. Only I would notice it.

I used this to patch some debased area on my sink. Worked perfectly. The only downfall is that my sink is brown and this patch kit comes only in white. Still it did the job and left a hard seal over the debased porous areas where water should not be. One thing to know is you can’t use only part of the bottle and then save the rest ~ it will harder in the jar and is useless.

Do NOT believe it when you read on the package that you just need to use this within 24 hours of mixing it. I mixed this last night, left, and came back this morning to put on another coat (only 14 hours later). Unfortunately, the container is full of white rubber. If I knew the product would be unusible in this amount of time, I would have stayed here longer last night and put on the second, and then third, coats before I left.My tub isn't anywhere near being sealed enough for me to continue with the surround installation amd now I have to put out more money for more product. That's not even to mention that I now have to wait over an extra WEEK to be able to finish the tub because a new order won't get to me until next Wednesday (it's currently Thursday). I only have one bathroom in my house and having to go another week with no tub/shower is a HUGE hardship.

It is paint, not really works good for porcelain. AND NOTE, they don't allow to return even you didn't open the package. Really bad buying experience

This seems to be a hybrid of epoxy (two parts you mix which then chemically react for a cure), and drying (where an organic solvent is released as it dries).This was used to repair the drain hole of a porcelain-coated steel tub. The drain was removed, and the entire area above and below the hole (between the drain and the tub shoe) was cleaned to remove rust which developed where the porcelain had chipped. The self leveling helped greatly in layering the paint to match the thickness of the missing porcelain.After almost one year of multiple showers a day, it is holding with no signs of wear or compromise.Cons:-Noxious vapors-Expensive for its sizePros:-Self leveling-Can be painted in multiple layers to achieve greater thickness-Predetermined quantities you mix without having to measure (bottles are seemingly half full, but only because you need to pour one into the other without overflow)-Cures within 24 hours-Seems to adhere with no signs of being compromised in the presense of water-Despite having covered a large area, there was plenty left over to use elsewhere and some remained unused in the bottle.

SUPER BRIGHT WHITE!!!! doesn't match my white tub, which was recently redone with "porcelain paint". Very easy to apply, high quality, dries quickly, but SUPER BRIGHT WHITE and touch up spots are quite visible. Otherwise, product serves its purpose very well.